Product Catalogs

Correctional Facilities Catalog
Jones Stephens Corp. Catalog
AO Smith Water Heater Replacement Catalog
Cyclone Brochure
Cyclone BTH Specs
Commercial Laundry Equipment Catalog
Commercial Food Equipment Catalog
Acorn Stainless Steel Toilets

Tidal Flush Technology

tidal flush technology

Tidal Flush(TM) is a toilet bowl with a revolutionary new design. This new toilet is manufactured using a rear discharge and a front mounted jet. Tidal Flush(TM) removes all waste on the first flush, every time.

The front mounted jet uses 90% of the water to emulsifies and push the waste out of the bowl. The older 1.6gpf toilets are manufactured with the flushing jet inside the waste tube. This requires the toilet to pull the waste into the trapway before final flushing can occur. Simply put, the older designs require several flushes to properly evacuate the waste.

Tidal Flush(TM) not only meets volume carry demands, but exceeds these standards by as much as 440%*. In fact, Tidal Flush works so well, it exceeds ASME and CSA volume carry standards at pressures as low as 25 psi (172 kPa).

Flex Flush Technology

flex flush technology

This revolutionary new bowl toilet design was the direct result of many requests from our customers. The older 1.6 gpf toilets use a 2 3/8" waste tube in the design. It has been documented these toilets need several flushes to evacuate waste. In addition many facilities are experiencing many nagging clogs from normal use. It seems the restrictive 2 3/8" waste tube is not large enough to evacuate normal waste under normal use. The goal for Metcraft was to design a 1.6 gpf toilet using a 3" waste tube which is normally used on the older 3.5 gpf toilets. The problem that had to be resolved was the hydraulics of this new unit. The larger waste design required that more water be used to reseal the trap and less water be used to flush and evacuate the waste.

After several years of experimentation, Flex Flush (TM) was invented. This new design gives you all of the water savings of older 1.6 gpf toilets while eliminating the nagging stoppages/clogging as a result of using the larger 3 inch waste tubes.

All of the other competitors still use the old 1.6 gpf design using the more restrictive 2 3/8" waste tube. This technology is 15 years old and costs your customers thousand of dollars over the life of the facility.

To ensuring your customer is receiving the most advanced product the industry can provide, specify Flex Flush (TM) on your next project. This will ensure your customers many years of cost savings resulting from this new revolutionary design.

A.O. Smith Hot Water Heaters

Cyclone XI Commercial Water Heater

cyclone xi hot water heater

The Cyclone models deliver extraordinary storage and dollar-savings with models up to 96% efficient. Four units can be manifolded to provide total storage of 520 gallons and total input of 2M BTU - ideal for mid-sized restaurants and 50-300 room hotels. The Cyclone is designed to fit in corners and flush against the wall for maximum installation flexibility.






GSA Ordering Information